1955 Corvette: Service Bulletin: Oil Pump Suction Pipe

Subject:  Oil Pump Suction Pipe
Model Year:  1955 6-Cylinder Engine
Date:  February 8, 1955
Bulletin Number: DR-197, Section VI

TO:  ALL CHEVROLET DEALERS

A new Oil Pump Suction Pipe for 1955 6-Cylinder Engines is now in production and available in Parts Stock which eliminates the possibility of loss of oil pump prime during oil changes which may occur in some units due to limit stack conditions.

New Oil Pipes entered production at the engine plants about 1-24-55.

PARTS DATA

SERVICE - INSTALLATION

• Remove oil pan from engine.
• Remove floating intake screen from pipe by bending tang on float travel stop.
• Remove Oil Pump suction Pipe by unscrewing from pump cover.  Clearance should be provided as necessary by rotating crankshaft.
• Install new Suction Pipe tightening it in pump cover until lower end of pipe is 7-1/8" below pan gasket surface on block.  This places the tube section the screen pivots on in a horizontal position.  Check pipe for clearing side of oil pan.
• Reinstall screen and oil pan.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.

© Copyright General Motors Corporation. All Rights Reserved.

Article ID: 174
Created: July 13, 2014
Last Updated: July 13, 2014

Online URL: https://www.corvetteactioncenter.com/tech/knowledgebase/article/1955-corvette-service-bulletin-oil-pump-suction-pipe-174.html