Corvette Action Center Knowledgebase

1997 - 2011 Corvette: Service Bulletin: #PIP4245A: Torque Tube Fully Serviceable - (Jun 20, 2011)

Mar 31, 2017 c5 corvette, c6 corvette, zr1, corvette zr1, c6 zr1, service bulletin, torque tube, driveline, axle, propeller shaft, repair, torque tube assembly, replacement 0 0 3339 5/5 (2 Votes)

#PIP4245A: Torque Tube Fully Serviceable - (Jun 20, 2011) Subject: Torque Tube Fully Serviceable Models: 2004 - 2009 Cadillac XLR, XLR-V 1997 - 2011 Chevrolet Corvette, Corvette Z06 2009 - 2011 Chevrolet Corvette ZR1 This PI was... Read More

2009 Corvette ZR1: Front Fascia Valence Panel Installation

Jul 6, 2014 2009 corvette, zr1, corvette zr1, front fasica, valence panel, installation, instruction, procedure 0 0 854 0/5 (0 Vote)

Below are the installation instructions for the carbon fiber front fascia valence panel on the 2009 ZR1: Read More

2009 - 2013 Corvette ZR1: GM TechLink: Brake Burnish Procedure

Jul 6, 2014 c6 corvette, zr1, corvette zr1, brake burnishing, brake burnish, brake burnish procedure, gm techlink 0 0 1940 0/5 (0 Vote)

This is a followup to the article on ZR1 ceramic brakes in the November 2008 issue of TechLink. NOTICE: These procedures are specific to the ZR1 with ceramic brake rotors. This procedure should not be run on other Corvette models as damage may... Read More

2009 Corvette ZR1: Campaign Recall: Clutch Spring Fracture-Replace Clutch

Jul 6, 2014 2009 corvette, zr1, corvette zr1, recall, recall notice, campaign, customer satisfaction, clutch spring, fracture, clutch 0 0 1272 0/5 (0 Vote)

#09160: Customer Satisfaction - Clutch Spring Fracture-Replace Clutch - (Jul 6, 2009)Subject: 09160 -- Clutch Spring Fracture -- Replace ClutchModels: 2009 Chevrolet Corvette ZR1 -----------------------------------------------------------------------... Read More

2009 - 2013 Corvette ZR1: GM TechLink: Ceramic Brake Rotors

Jul 5, 2014 corvette zr1, zr1, c6 zr1, c6 corvette, brake rotors, ceramic, gm techlink, brakes, rotors, cleaning, rotor mass 0 0 5636 3.67/5 (3 Votes)

The ZR1 Corvette is equipped with ceramic brake rotors (fig. 4 and 5) , which offer a number of benefits over cast iron rotors: - No fading - Wet effectiveness - No thermal deflection - Consistent pedal travel - No corrosion -... Read More

2006 - 2009 Corvette Z06 and ZR1: GM TechLink Article: Oil Reservoir Rattle

Jul 5, 2014 corvette z06, corvette zr1, z06, zr1, c6 corvette, ls7, ls9, rattle, tapping, noise, internal transfer tube, o-ring, gm techlink, oil tank, replacement 0 1 2133 0/5 (0 Vote)

Some owners of a 2006-09 Corvette Z06 or a 2009 Corvette ZR1 with 6.2L or 7.0L Engine (VINs R, E -- RPOs LS9, LS7) may comment on a rattle or tapping type noise that is heard under the hood just above idle, usually 1200 to 2200 RPM. In some cases,... Read More

2006 - 2009 Corvette Z06 and ZR1: GM TechLink: Excess Oil in Air Intake Snorkel

Jul 5, 2014 c6 corvette, zr1, z06, c6 zr1, c6 z06, corvette zr1, corvette z06, ls7, ls9, excess oil, air intake, snorkel, ses light, dtcs, gm techlink 1 0 1690 3.5/5 (4 Votes)

Some owners of a 2006-09 Corvette with a 7.0L engine (RPO LS7), a 2008-09 Corvette with 6.2L engine (RPO LS3) or a 2009 Chevrolet Corvette with 6.2L supercharged engine (RPO LS9) may complain of a SES light. Upon inspection, oil in the air cleaner, a... Read More

2009 - 2013 Corvette ZR1: GM TechLink: Installing ZR1 Body Kit

Jul 5, 2014 corvette zr1, zr1, body kit, install, installing, how-to, gm techlink, rear wheel flares, rocker moldings, rotor protectors, front valance 0 0 1011 0/5 (0 Vote)

Some of the carbon fiber trim is not installed to the ZR1 at the assembly plant, to avoid shipping damage. The body side lower rear (rocker) moldings, front valance panels and rear wheel opening front flares must be installed at the dealership during... Read More

2009 - 2013 Corvette ZR1: GM TechLink: Lifting the Corvette ZR1

Jul 5, 2014 corvette zr1, zr1, c6 zr1, lift, lifting, gm techlink, lifting procedure, lifting tips 0 0 3571 0/5 (0 Vote)

IMPORTANT: Some of the ZR1 carbon fiber trim is not installed to the vehicle at the assembly plant, to avoid shipping damage. The rocker moldings, front valance panels and rear wheel flare moldings must be installed at the dealership during new... Read More

2009 Corvette Z06 and ZR1: GM TechLink Article: Oil System Changes - LS7 and LS9

Jul 5, 2014 2009 corvette, z06, zr1, corvette z06, corvette zr1, ls7, ls9, dry-sump, engine oil, gm techlink, oil pump, oil cooler, oil pan 0 1 8799 4.56/5 (9 Votes)

Changes have been made to the dry-sump engine oil system used in the 2009 Corvette (fig. 1) . This information pertains to these two engines: - LS7 7.0L -- used in the Z06 ... Read More

Articles Search Results